Wolverine Blend Dosage Calculator & Chart

1Set Up Your Mix

5 mg/mL · 5000 mcg/mL

1. Pick your peptide

2. How much peptide is in the vial? It's printed on the label — usually something like 5 mg

3. How much water are you adding? More water makes each dose easier to measure

4. How much do you want per dose?

Your Answer — Wolverine Blend

10 mg in 2 mL

10Draw To This Line

0.1That's This Many mL

20Doses In The Vial

10 mg ÷ 2 mL = 5 mg/mL → 500 mcg ÷ 5 mg/mL = 0.1 mL → × 100 = 10 units

Looks good. Draw to 10 units on a 1 mL syringe. That is an easy amount to measure, and this vial gives you 20 doses.

When to dose

Time of dayNo particular time of day has been established.

FoodNo fasting requirement has been established.

The studies behind this compound did not test timing or food state as variables, so we are not going to invent a rule. Pick a time you can keep to consistently.

2Week-By-Week Plan — Wolverine Blend

Start low, work up

When	Dose	How Often	How Many mL	Draw To	Number Of Doses	Peptide Used
Weeks 1–2	500 mcg	daily	0.1 mL	10 u	14	7 mg
Weeks 3–4	1000 mcg	daily	0.2 mL	20 u	14	14 mg
Week 5 onward per 4 weeks from here on	1500 mcg	daily	0.3 mL	30 u	28	42 mg

Time until the top dose

4 weeks

Peptide used getting there

21 mg

Vials you'll need

3 × 10 mg

Once you're at the top dose

42 mg / 4 wk · 4.2 vials

Where this plan came from

Built from this peptide's dose range

Where this came from: Built from the doses listed for this peptide below — start at the lowest and step up, using the studies cited on this page. Nobody publishes a week-by-week plan for this peptide, so we built one: the doses are the researched ones shown below, and we simply put them in order from lowest to highest. Treat it as a starting point, not an official schedule.

3Common Doses — Wolverine Blend

worked out for your mix

Level	Dose	How Often	How Many mL	Draw To	Doses In Vial
Low reported	500 mcg	1× daily · 250 mcg of each compound	0.1 mL	10 u	20 doses
Standard	1000 mcg	1× daily · 500 mcg of each compound	0.2 mL	20 u	10 doses
Upper reported	1500 mcg	1× daily · 750 mcg of each compound	0.3 mL	30 u	6 doses

Please read this. These numbers come from published research. They are here as reference, not as instructions. A lot of them come from lab studies rather than studies in people, and some of these peptides have never been given to a person at all.

About Wolverine Blend

Multi-Compound Blends

Also known as

BPC-157 5 mg + TB-500 5 mg

Class

Multi-Compound Blends

Route

Subcutaneous

Half-life

Mixed

Evidence tier

Preclinical

The most common repair blend, equal parts BPC-157 and TB-500. Two sizes: the 10 mg vial holds 5 mg of each, the 20 mg vial holds 10 mg of each. The split is 50/50 either way, so every dose delivers half of it to each component regardless of which vial you have — a 1000 mcg dose is 500 mcg of each. The vial size changes how many doses you get, not the ratio. Switch the vial strength above to match what you are holding.

Buy Wolverine Blend

Research Equipment

SyringesU-100 insulin · 1 mL · 29–31G

Alcohol wipes70% isopropyl prep pads

Serum base — for topical mixesHyaluronic acid serum for mixing peptides into a serum

Electric cooler caseTSA-approved travel cooler — keeps mixed vials at fridge temperature

Storage caseHard carry case for vials

Paid affiliate links.

Common Questions — Wolverine Blend

How much bacteriostatic water do I add to a 10 mg vial of Wolverine Blend?

Adding 2 mL of bacteriostatic water to a 10 mg vial gives 5 mg/mL. That is the mix every number on this page is worked out from — change the water figure in the calculator and all the draw amounts update.

What dose of Wolverine Blend is used in research?

Published and reported figures for Wolverine Blend run from 500 mcg to 1500 mcg, typically 1× daily (250 mcg each). This site lists each figure with the source it came from rather than giving a single recommended number.

How many units on the syringe is a 500 mcg dose of Wolverine Blend?

At 5 mg/mL, a 500 mcg dose is 10 units on a 1 mL U-100 insulin syringe. One vial at that mix gives about 20 doses.

How strong is the evidence behind these Wolverine Blend doses?

Wolverine Blend is graded preclinical. Laboratory and animal data only. No human dosing trials have been published. We grade every compound on this site so you can weigh the numbers accordingly — the full method is on our editorial policy page.

Why BPC-157 and TB-500 are paired

10/20 mg vial

What is in the vial

BPC-157 5 mg
TB-500 5 mg

This is the most common repair pairing, and it is an even split. Both compounds are studied for tissue repair, but the preclinical work points at different parts of the process — BPC-157 more toward tendon, ligament and gut, TB-500 more toward cell migration and remodelling.

The argument for combining them is that those are complementary rather than overlapping mechanisms. It is worth being clear that this is a reasoned argument, not a demonstrated one: there is no published human trial of either compound alone, let alone together.

The ratio matters. An even 50/50 split, so a 500 mcg dose is 250 mcg of each. That is unusual among these blends — most are weighted.

Where These Numbers Come From

Preclinical — Preclinical and in-vitro data only — no human dosing trials

See component entries: BPC-157, TB-500 No blend-specific literature exists

No controlled study has tested the combination against either component alone.

Find on PubMed ↗

Newest Studies — —

—

Not reviewed by us. This list is pulled straight from Europe PMC as papers are published. Nobody has checked whether these are any good, or whether they change anything above. The dose numbers on this page only ever change after a person reviews the evidence.

Wolverine Blend Dosage & Reconstitution